Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the SRX Series Services Gateway
To maintain proper airflow through the services gateway, leave blank faceplates in place over slots that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs). Do not remove a blank faceplate unless you are installing a GPIM in the empty slot.
To remove a blank faceplate:
- Using a Phillips (+) screwdriver, loosen the captive screws on each side of the blank faceplate.
- Using a flat-blade (–) screwdriver, gently pry out one side of the faceplate and pull it off.
 | Note: When installing a blank GPIM faceplate, make sure that the padded side of the faceplate is facing up. |
Related Topics
- Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway
- Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway
- Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services Gateway
- Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module
