• Supported Platforms
• M7i Routers

• Related Topics
• Installing an SFP into an M7i Router
• Replacing an SFP on an M7i Router

Inserting an SFP into the 1-port Gigabit Ethernet FIC

Before inserting cables into the 1-port Gigabit Ethernet FIC, you must install a small form-factor pluggable (SFP). Small form-factor pluggable (SFP) optical transceiver modules provide support for SX, LX, and LH optics.

To install an SFP into the FIC, follow this procedure:

1. Verify that each SFP has a rubber safety cap covering the optical transceiver. If it does not, cover the transceiver with a safety cap.
2. Carefully align the SFP with the slot in the FIC. The connector should face down.
3. Slide the SFP until the connector is seated in the FIC slot. If you are unable to fully insert the SFP, make sure the connector is facing the proper direction.