Removing a T320 Front Fan Tray
The upper front fan tray is located above the FPC card cage, and the lower front fan tray is located below the front air filter. Each fan tray weighs about 13.3 lb (6.0 kg).
To remove a front fan tray (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series Router.
- If you are removing the lower fan tray:
- Unwrap any PIC cables from the spools on the cable management
system and remove the cables from the tray. Arrange the cables so
that they do not block the front of the cable management system and
tray, and secure them with temporary fasteners so that they are not
supporting their own weight as they hang from the connector.
Caution: Do not let fiber-optic cable hang free from the connector. Do not allow fastened loops of cable to dangle, which stresses the cable at the fastening point.
- Simultaneously pull the two releases on the cable management system. Lift it up and outward to lock it in place to access the lower fan tray.
- Unwrap any PIC cables from the spools on the cable management
system and remove the cables from the tray. Arrange the cables so
that they do not block the front of the cable management system and
tray, and secure them with temporary fasteners so that they are not
supporting their own weight as they hang from the connector.
- Loosen the captive screws on the corners of the fan tray faceplate.
- Grasp the handles and pull the fan tray halfway
out of the chassis.
Warning: To avoid injury, keep tools and your fingers away from the fans as you slide the fan tray out of the chassis. The fans might still be spinning.
- When the fans stop spinning, place one hand under the fan tray to support it and pull the fan tray completely out of the chassis.
Figure 1: Removing a Front T320 Fan Tray
