• Supported Platforms
• JCS 1200

• Related Topics
• Preventing Electrostatic Discharge Damage to the JCS1200 Platform
• JCS1200 Fan Module Description
• Removing a JCS1200 Fan Module

Installing a JCS1200 Fan Module

Figure 1 shows how to remove and install a fan module.

To install a fan module (see Figure 1):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Orient the fan module to the selected fan module bay.

   Figure 2: Fan Module Orientation Marks

   

   1. If you are installing a fan module in fan module bay 1 or 2, orient the fan so the orientation mark is at the bottom-right corner.
   2. If you are installing a fan module in fan module bay 3 or 4, orient the fan so the orientation mark is at the top-left corner.
3. Slide the fan module into the bay until it stops.

   Note: Make sure the release levers for the fan module return to a locked position.

4. If you are shipping the JCS1200 platform to another location, install the shipping block that came with the platform.

   Note: When the JCS1200 platform is shipped, a shipping block must be installed for each fan module. The shipping block is installed below the release lever that is on the same side as the fan module orientation mark.

   Figure 3: Installing the JCS1200 Shipping Block

   

   1. Orient the shipping block below the release lever on the same side as the orientation mark on the fan module.
   2. Push the shipping block into the slot below the release lever.
   3. Install the Phillips screw that attaches the shipping block to the platform.