• Downloads
• Removing the SRX5600 Services Gateway Craft Interface    

• Related Topics
• Preventing Electrostatic Discharge Damage to the SRX5600 Services Gateway
• Tools and Parts Required to Replace SRX5600 Services Gateway Hardware Components
• Disconnecting the Alarm Relay Wires from the SRX5600 Services Gateway Craft Interface
• Installing the SRX5600 Services Gateway Craft Interface
• Connecting the Alarm Relay Wires to the SRX5600 Services Gateway Craft Interface

Removing the SRX5600 Services Gateway Craft Interface

To remove the craft interface (see Figure 1):

2. Detach any external devices connected to the craft interface.
3. Loosen the captive screws at the top left and right corners of the craft interface faceplate.
4. Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
5. Disconnect the ribbon cable from the back of the faceplate by gently pressing on both sides of the latch with your thumb and forefinger. Remove the craft interface from the chassis.

Figure 1: Removing the Craft Interface