• Downloads
• Disconnecting the Alarm Relay Wires from the SRX5600 Services Gateway Craft Interface    

• Related Topics
• Preventing Electrostatic Discharge Damage to the SRX5600 Services Gateway
• Tools and Parts Required to Replace SRX5600 Services Gateway Hardware Components
• Removing the SRX5600 Services Gateway Craft Interface
• Installing the SRX5600 Services Gateway Craft Interface
• Connecting the Alarm Relay Wires to the SRX5600 Services Gateway Craft Interface

Disconnecting the Alarm Relay Wires from the SRX5600 Services Gateway Craft Interface

To disconnect the alarm relay wires from the services gateway and an alarm-reporting device (see Figure 1):

1. Disconnect the existing wire at the external device.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
3. Using a 2.5-mm flat-blade screwdriver, loosen the small screws on the face of the terminal block and remove the block from the relay contact.
4. Using the 2.5-mm flat-blade screwdriver, loosen the small screws on the side of the terminal block. Remove existing wires from the slots in the front of the block.

Figure 1: Alarm Relay Contacts