Setting the M/S Configuration Switches on the T1600 LCC-CBs
You configure a T1600 chassis ID by setting a physical switch on each LCC-CB faceplate in the T1600 router (see ).
To set the M/S configuration switches:
- Set the M/S switch on each LCC-CB faceplate to M.
- Verify that the chassis ID switch on each LCC-CB
is set to a value of 0. You must use the same chassis ID on each LCC-CB
on the T1600 router.
You must follow these requirements when setting the LCC-CB ID switches during the integration of an operational T1600 router:
- You assign a chassis ID of 0 to the router. Both LCC-CBs in a T1600 router must be set to 0. The switch setting must be unique within the routing matrix.
- The switch settings must match where the control cables are connected on the LCC-CB.
