• Supported Platforms
• TX Matrix Plus Routers

• Related Topics
• TX Matrix Plus TXP-CB Overview
• TX Matrix Plus Cables Overview
• TX Matrix Plus Routing Engine Interface Cable Specifications
• RJ-45 Connector Pinouts for the TX Matrix Plus Routing Engine AUXILIARY and CONSOLE Ports
• TX Matrix Plus Preventing Electrostatic Discharge Damage

Connecting the TX Matrix Plus Router to a Management Console or Auxiliary Device

Attach one or more management console or auxiliary devices to the Routing Engine ports on each TXP-CB for management and service operations (see Figure 1).

To connect the cables for a management console or auxiliary device:

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.

   Caution: During the initial installation before the chassis is grounded, you must connect to an approved site ESD point. See the instructions for your site.

2. If necessary, turn off the power to the console or auxiliary device.
3. Plug one end (shown in Figure 2) of a serial cable into the CONSOLE or AUXILIARY port on the TXP-CB in slot CB0. This port connects to the Routing Engine installed into the TXP-CB in slot CB0.
4. Attach the other end of the cable to the console or auxiliary device.
5. Plug one end of another serial cable into the CONSOLE or AUXILIARY port on CB1. This port connects to the Routing Engine installed into the TXP-CB in slot CB1.
6. Attach the other end of the cable to the console or auxiliary device.