• Supported Platforms
• T1600 Routers

• Related Topics
• T1600 Routing Engine Interface Cable and Wire Specifications
• Maintaining the T1600 Routing Engines
• Overview of Connecting the T1600 Router to Management and Alarm Devices

Replacing a T1600 Management Ethernet Cable

To replace the management Ethernet cables:

1. Press the tab on the connector and pull the connector straight out of the ETHERNET port. Figure 1 shows the connector.
2. Disconnect the cable from the network device.
3. Plug one end of the replacement cable into the appropriate ETHERNET port. The ports labeled HOST 0 connect to the Routing Engine in the upper Routing Engine slot (RE0), and the ports labeled HOST 1 connect to the Routing Engine in the lower Routing Engine slot (RE1).
4. Plug the other end of the cable into the network device.