AX411 Access Point Setup Overview
After you have prepared your installation site, you are ready to unpack and install the AX411 Access Point. It is important to proceed through the installation process as described in Table 1.
When you install the access point as described in Table 1, the services gateway loads a default configuration onto the access point, which establishes basic WLAN parameters.
After you have set up the access point and established basic WLAN connectivity, see the JUNOS Software WLAN Configuration and Administration Guide and JUNOS Software CLI Reference for information on performing advanced WLAN configuration.
Table 1: Installation Process Order for the AX411 Access Point
Step | Task | For More Information |
|---|---|---|
1 | Review the safety guidelines. | |
2 | Verify that you have prepared your site for the installation of the access point using the checklist. | |
3 | Unpack the access point and verify that all parts are present. | |
4 | Install the access point. | Installing the AX411 Access Point on a Flat Surface |
5 | Connect the access point to the SRX Series device and to power. | Installing the AX411 Access Point Antennas Connecting the AX411 Access Point to the SRX Series Device Providing Power to the AX411 Access Point Using Power over Ethernet Providing Power to the AX411 Access Point Using the Power Supply |
6 | Configure the wireless LAN. | AX411 Access Point Wireless LAN Initial Software Configuration OverviewInstalling Licenses for the AX411 Access Point on the SRX Series DeviceConfiguring AX411 Access Point Country-Specific Settings |
7 | Test connectivity to the wireless LAN. |
