• Downloads
• Connecting an SRX210 Services Gateway to the CLI Locally    

• Related Topics
• Connecting an SRX210 Services Gateway to the CLI Remotely
• Performing Initial Software Configuration on the SRX210 Services Gateway Using the CLI
• Connecting an SRX210 Services Gateway to the J-Web Interface
• SRX210 Services Gateway Software Configuration Overview
• SRX210 Services Gateway Secure Web Access Overview

Connecting an SRX210 Services Gateway to the CLI Locally

If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect through the console port, as shown in Figure 1.

Note: Figure 1 shows a connection to a local management device. A remote connection to the services gateway through a modem requires the cable and connector shown (provided in the services gateway accessory box), plus a DB-9 female to DB-25 male (or similar) adapter for your modem, which you must purchase separately.

To connect to the CLI using a local management device through the console port on the services gateway:

1. Turn off power to the services gateway.
2. Turn off power to the management device, such as a PC or laptop computer, that you are using to access the CLI.
3. Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45 to DB-9 serial port adapter supplied with your services gateway (see Figure 1).
4. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management device (see Figure 1).
5. Connect the other end of the Ethernet cable to the console port on the services gateway (see Figure 1).
6. Turn on the power to the management device.
7. Start your asynchronous terminal emulation application (such as Microsoft Windows HyperTerminal) and select the appropriate COM port to use (for example, COM1).
8. Configure the port settings shown in Table 1.

   Table 1: Port Settings when Connecting to Console Port

   Port Settings	Value
   Bits per second	9600
   Data bits	8
   Parity	None
   Stop bits	1
   Flow control	None

9. Power on the services gateway by pressing the Power button on the front panel.
10. Verify that the Power LED on the front panel turns green.

    The terminal emulation screen on your management device displays the startup sequence. When the services gateway has finished starting up, a login prompt appears.

11. Log in as the user root. No password is required at initial connection, but you must assign a root password before committing any configuration settings.