• Related Topics
• ADSL2+ Mini-Physical Interface Module Overview
• ADSL2+ Mini-Physical Interface Module Hardware Specifications
• ADSL2+ Mini-Physical Interface Module Network Interface Specifications
• Supported Standards on the ADSL2+ Mini-Physical Interface Module
• Key Features of the ADSL2+ Mini-Physical Interface Module
• ADSL2+ Mini-Physical Interface Module LEDs

Basic Configuration of the ADSL2+ Mini-Physical Interface Module

Using J-Web

To perform basic configuration for the ADSL2 Mini-PIM and to configure network interfaces for the services gateway with J-Web:

1. In J-Web, select Configure>Interfaces.

   The Interfaces page displays and lists the network interfaces present on the services gateway, along with configuration information (if configured).

2. To configure properties for a network interface (Mini-PIM), select the interface name (at-1/0/0), and click Edit.
3. To use the port on the Mini-PIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
   1. Select Configure>Security>Zones.
   2. Add or select a security zone other than Null; for example, Trust.
   3. For host inbound traffic, set the following:
      • System Services=Allow All
      • Protocols=Allow All
   4. Click OK to save changes, and click Commit to apply the configuration and other pending changes.
4. To use the port on the Mini-PIM, you must also set security policies. Select the following settings:
   1. Select Configure>Security>Policy>FW Policies.
   2. Set Policy Action: Default Policy Action=Permit-All.
   3. Click OK to save changes, and click Commit to apply the configuration and other pending changes (if any).

   See the Junos OS Network Interfaces Configuration Guide for more details.

Using the CLI

To perform basic configuration for the ADSL2+ Mini-PIM and to configure network interfaces for the services gateway with the CLI:

• Verify that the serial interface is installed on the device:

  show chassis hardware

• Verify the status of the interface:

  show interfaces terse

• Assign the port an IP address:

  set interface at-1/0/0 unit 0 family inet address interface address/destination prefix

• Add or select a security zone; for example, Trust:

  set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic system-services all

• Add or select security zones for host inbound traffic protocol options:

  set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic protocols all

• Set security policies:

  set security policies default-policy permit-all

See the Junos OS Network Interfaces Configuration Guide for more details.