Verifying the State of the Routing Matrix Control Plane
Purpose
After the T1600 router has booted, verify the state of the the routing matrix control plane.
Action
To verify that the routing matrix control plane is operating correctly:
- Issue the show chassis ethernet-switch sfc
0 command.
Verify that the link to the T1600 router (LCClcc-number) is good. For example, Link is good on GE port 2 connected to device: LCC1.
Note: The throughput of the control plane connections between the TX Matrix Plus router and the T1600 routers is 1000 Mbps. The throughput of the connections between Routing Engines in a TX Matrix Plus router is 10 Gbps.
user@host> show chassis ethernet-switch sfc 0sfc0-re0: -------------------------------------------------------------------------- Displaying summary for switch 0 Link is good on XE port 1 connected to device: 1GSW Speed is 10000Mb Duplex is full Autonegotiate is Disabled Link is good on XE port 9 connected to device: RE1 Speed is 1000Mb Duplex is full Autonegotiate is Disabled Link is good on XE port 17 connected to device: RE0 Speed is 1000Mb Duplex is full Autonegotiate is Disabled Displaying summary for switch 1 Link is good on GE port 0 connected to device: LCC0 Speed is 1000Mb Duplex is full Autonegotiate is Enabled Link is good on GE port 2 connected to device: LCC1 Speed is 1000Mb Duplex is full Autonegotiate is Enabled Link is good on GE port 4 connected to device: LCC2 Speed is 1000Mb Duplex is full Autonegotiate is Enabled Link is good on GE port 6 connected to device: LCC3 Speed is 1000Mb Duplex is full Autonegotiate is Enabled Link is good on GE port 18 connected to device: SPMB Speed is 1000Mb Duplex is full Autonegotiate is Enabled Link is good on XE port 26 connected to device: 10GSW Speed is 10000Mb Duplex is full Autonegotiate is Disabled
