TX Matrix DC Power Distribution
Most sites distribute DC power through a main conduit that leads to frame-mounted DC power distribution panels, one of which might be located at the top of the rack that houses the router. A pair of cables (one input and one return) connects each set of terminal studs to the power distribution panel.
 | Note: All inputs on the two-input 160-A DC power supply in slot PEM0 must be powered by dedicated power feeds derived from feed A, and all inputs on the two-input 160-A DC power supply in slot PEM1 must be powered by dedicated power feeds derived from feed B. This configuration provides the commonly deployed A/B feed redundancy for the system. |
| Note: INPUT 0 and INPUT 1 on the three-input 240-A DC power supply in slot PEM0 must be powered by dedicated power feeds derived from feed A, and INPUT 0 and INPUT 1 on the three-input 240-A DC power supply in slot PEM1 must be powered by dedicated power feeds derived from feed B. This configuration provides the commonly deployed A/B feed redundancy for the system. |
Figure 1 shows a typical DC source cabling arrangement.
Figure 1: Typical DC Source Cabling from PEM0 to Feed A
Figure 2: Typical DC Source Cabling from PEM1 to Feed B
