Technical Documentation

AC Power Supply LEDs in an EX8200 Switch

An AC power supply has three LEDs on its faceplate. These LEDs display information about the status of the power supply. See Figure 1.

Figure 1: AC Power Supply LEDs on an EX8200 Switch

Image g020511.gif

Table 1 describes the LEDs on an AC power supply in an EX8200 switch.

Table 1: Power Supply LEDs on EX8200 Switches

LED State Description

INPUT OK

Unlit

Indicates one of the following:

  • Power supply is disconnected from AC power feed.
  • AC power input voltage is not within normal operating range.
  • No AC power input.

Green
  • AC power input voltage is high line (200–240 VAC).

Yellow

Note: This LED state applies only to 2000 W AC power supplies.

  • AC power input voltage is low line (100–120 VAC).

OUTPUT OK

Unlit

Indicates one of the following:

  • DC output voltage is not within normal operating range.
  • Power supply is not supplying DC power correctly.

Green
  • DC power output is within normal operating range.

Yellow
  • Power supply has been disabled internally by the system.

FAIL

Unlit
  • Power supply is functioning normally.

Yellow
  • On steadily—Power supply has failed.
  • Blinking—Demand for output power exceeds the supply.

Note: If the INPUT OK LED and the OUTPUT OK LED are unlit, the AC power cord is not installed properly or the power supply has failed.

If the INPUT OK LED is lit and the OUTPUT OK LED is unlit, the AC power supply is not installed properly or the power supply has an internal failure.

If the FAIL LED is lit, the power supply has failed and must be replaced. If the FAIL LED is blinking, add a power supply to balance the power demand and supply.

Published: 2009-07-15