Network Port and Uplink Port LEDs in EX2200 Switches
Each network port and uplink port on the front panel of an EX2200 switch has two LEDs that indicate link/activity and port status. See Figure 1 and Figure 2.
Figure 1: LEDs on the Network Ports on the Front Panel
Figure 2: LEDs on the Uplink Ports and Port Status Mode LEDs
Table 1 describes the Link/Activity LED.
Table 1: Link/Activity LED on the Network Ports and Uplink Ports in EX2200 Switches
State and Description |
|---|
|
The LEDs labeled Status LED in Figure 1 and Figure 2 indicate the status of one of the four port parameters—speed, duplex mode, administrative status, and Power over Ethernet (PoE) status. Use the mode button below the POE LED on the far right side of the front panel to toggle the Status LED to show the different port parameters. You can tell which port parameter is indicated by the Status LED by seeing which port status mode LED (SPD, DX, EN, and POE) is lit. (See Figure 2).
Table 2 describes the Status LED.
Table 2: Status LED on the Network Ports and Uplink Ports in EX2200 Switches
Port Parameters | State and Description |
|---|---|
Speed | Indicates the speed. The speed indicators for network ports are:
The speed indicators for uplink ports are:
|
Duplex mode | Indicates the duplex mode. The status indicators are:
|
Administrative status | Indicates the administrative status. The status indicators are:
|
PoE status | Indicates the PoE status. The status indicators for network ports are:
PoE is not available on uplink ports; therefore, the LED for those ports is always unlit. |
You can tell which port parameter is indicated by the Status LED on network ports and uplink ports by issuing the operational mode command show chassis led.
