RJ-45 Connector Pinouts for the TX Matrix Plus Routing Engine ETHERNET Port
The port on the TXP-CB labeled ETHERNET is an autosensing 10/100-Mbps/1-Gbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or other device that supports management of the routing matrix). Table 1 describes the RJ-45 connector pinout.
Table 1: RJ-45 Connector Pinout for the TX Matrix Plus ETHERNET Port
Pin | Signal |
|---|---|
1 | TX+ |
2 | TX – |
3 | RX+ |
4 | Termination network |
5 | Termination network |
6 | RX– |
7 | Termination network |
8 | Termination network |
