Tools and Parts Required to Replace M40e Hardware Components
To replace hardware components, you need the tools and parts listed in Table 1.
Table 1: Tools and Parts Required to Replace M40e Hardware Components
Tool or part | Components |
|---|---|
Electrostatic bag or antistatic mat | CIP Craft interface FPC Front impeller assembly MCS PIC PCG Routing Engine SFM |
Electrostatic discharge (ESD) grounding wrist strap | All |
Flat-blade (–) screwdriver, 2.5 mm | Alarm relay contacts on CIP |
Flat-blade screwdriver, approximately 1/4 in. (6 mm) | Craft interface Front impeller assembly |
Phillips (+) screwdrivers, numbers 1 and 2 | Air filter CIP Circuit breaker box Craft interface DC power cables (to remove protective shield over circuit breaker box) Fan tray Fuse (to remove rear lower impeller assembly) Impeller assembly PCG PIC Power supply (AC or DC) Routing Engine SFM |
7/16-in. hexagonal-head external drive socket wrench, or nut driver, with a torque range between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) | Circuit breaker box (to remove or install power cables) DC power cables |
Wire cutters | Alarm relay contacts on CIP |
Rubber safety cap | Fiber-optic PIC or PIC cable |
