Technical Documentation

Channelized STM1 to E1 PIC (M40e Router)

Image g001469.gif

Software release

  • Junos OS Release 5.2 and later

Description

  • One E3 port
  • Power requirement: 0.32 A/48 V @ 15.3 W
  • 63 E1 channels

Hardware features

  • Each E1 channel supports a single High-Level Data Link Control (HDLC) framer that can be configured for speeds from DS0 (64 Kbps) through full E1 (2 Mbps) in 64-Kbps increments
  • Onboard DSU functionality for E1 and fractional E1 connectivity
  • Integrated support for G.703 and unframed mode and G.704 framed mode with CRC; this feature is user-configurable
  • Configurable clock source: Internal or loop
  • Per-port loop timing
  • Rate limiting on input and output
  • NxE1 service with Multilink Point-to-Point Protocol (MLPPP, RFC 1990) delivered by the Link Services and Multilink Services PICs

Software features

  • SDH mapping:
    • Tributary Unit Group 3 (TUG-3)
  • E1 support:
    • Full instrumentation per E1 channel
    • Integrated support for G.703 unframed mode and G.704 framed mode
    • 4-bit CRC for G.704 framed mode
    • HDB3 coding
    • Local E1 line loopback and remote line loopback
    • Per-channel BERT testing
  • Encapsulations:
    • Cisco High-Level Data Link Control (HDLC)
    • Frame Relay
    • Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC)
    • MPLS translational cross-connect (TCC)
    • Point-to-Point Protocol (PPP)

Cables and connectors

  • Single-mode fiber
  • Duplex SC/PC connector (RX and TX)

LEDs

One tricolor per port:

  • Off—Not enabled
  • Green—Online with no alarms or failures
  • Yellow—Online with alarms for remote failures
  • Red—Active with a local alarm; router has detected a failure

Alarms, errors, and events

  • Alarm indication signal (AIS)
  • Bit error rate signal degrade (BERR-SD), bit error rate signal fail (BERR-SF)
  • Bit error rate testing (BERT) per E1 channel
  • Bit interleaved parity errors B1, B2, B3 (CV-S, CV-L, CV-P)
  • Loss of frame (LOF), loss of pointer (LOP-P), loss of Signal (LOS)
  • Payload mismatch (PLM-P), payload unequipped (UNEQ-P)
  • Remote defect indication (RDI-L, RDI-P)
  • Errored seconds (ES-S, ES-L, ES-P), severely errored framing (SEF), severely errored framing seconds (SEFS-S), severely errored seconds (SES-S, SES-L, SES-P), unavailable seconds (UAS-L, UAS-P)
  • Yellow alarm bit (X-bit) disagreements

Published: 2010-08-14

Help
|
My Account
|
Log Out