Software release

• Junos OS Release 6.3 and later

Description

• One Gigabit Ethernet port
• Power requirement: 0.15 A @ 48 V (7.3 W)
• Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network

Hardware features

• High-performance throughput on each port at speeds up to 1 Gbps
• Autonegotiation between Gigabit Ethernet circuit partners
• Full-duplex mode
• Maximum transmission units (MTUs) of up to 9192 bytes

Software features

• Virtual Router Redundancy Protocol (VRRP) support
• 802.1q virtual LANs (VLANs) support
• 960 destination MAC filters per port
• Flexible Ethernet encapsulation
• Multiple tag protocol identifiers (TPID) support
• Source MAC learning
• MAC accounting and policing—Dynamic local address learning of source MAC addresses

Cables and connectors

• You can install any transceiver supported by the PIC.
• Fiber-optic SFP transceivers:
  • Duplex LC/PC connector (Rx and Tx)

Note: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize the SFP.

LEDs

Status LED, one bicolor:

• Off—PIC is not enabled.
• Green—PIC is operating normally.
• Red—PIC has an error or failure.

Port LEDs, one pair per port:

• Link—If green, the port is online; if there is no light, the port is down.
• Activity—If flashing green, the port is receiving data; if there is no light, the port might be on but is not receiving data.