Software release

• Junos OS Release 8.4 and later

Description

• Four 10-Gigabit Ethernet ports
• Power requirement: 6.46 A @ 48 V (310 W)
• Weight: 13.1 lb (5.9 kg)
• Model number: DPCE-X-4XGE-XFP

Hardware features

• High-performance throughput on each port at speeds up to 10 Gbps
• WAN-PHY mode at 9.953 Gbps
• LAN-PHY mode at 10.3125 Gbps
• Full-duplex mode
• Maximum transmission units (MTUs) of up to 9192 bytes
• Enhanced ASICs for increased performance and scalability of Layer 2 features

Software features

• Configurable WAN-PHY mode options
• See Protocols and Applications Supported by MX Series Enhanced Ethernet Services DPCs (DPCE-X) for information about the protocols and applications that this DPC supports.

Note: The routing table is limited to 32,000 IP routes. This limitation applies to any manner in which the routes are learned, such as OSPF, RIP, and so on. The DPC supports BGP for L2 VPNs only.

Cables and connectors

• You can install any transceiver supported by the DPC. For information about installing and removing transceivers, see the hardware guide for your router.
• Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
  • Connector: Duplex LC/PC (Rx and Tx)
  • 10GBASE-E (model number: XFP-10G-E-OC192-IR2)
  • 10GBASE-L (model number: XFP-10G-L-OC192-SR1)
  • 10GBASE-S (model number: XFP-10G-S)
  • 10GBASE-Z (model number: XFP-10G-Z-OC192-LR2)

  Optical interface specifications—see 10-Gigabit Ethernet Optical Interface Specifications

• DWDM Tunable XFP transceivers:
  • Connector: Duplex LC/PC (Rx and Tx)
  • 10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR)

    DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver Wavelengths

    Note: XFP-10G-CBAND-T50-ZR is supported in Junos OS Release 10.2 and later

  Optical interface specifications—see 10-Gigabit Ethernet Optical Interface Specifications

LEDs

OK/FAIL LED, one bicolor:

• Steady green—DPC is functioning normally.
• Blinking green—DPC is transitioning online or offline.
• Red—DPC has failed.

TUNNEL LED, one green per port:

• Off—Normal operating mode.
• On steadily—Port configured in tunnel mode.

LINK LED, one green per port:

• Off—No link.
• On steadily—Link is active.

The TUNNEL and LINK LEDs are labeled top to bottom 0/0 through 3/0.