• Download Software
• Research a Problem 
• Case Management 
• Contract & Product Management 
• Technical Documentation
  • Advanced Search
  • Documentation Archive
  • Documentation Bug Report
  • Enterprise MIBs
  • File Format Help
  • Glossary
  • Portable Libraries
• End-of-Life Products
• Contact Support
• Guidelines and Policies
• Security Resources

TX-CIP Description

The TX Matrix router contains one or two TX-CIPs—one for each Routing Engine—that install vertically into the front left of the chassis in the slots labeled CIP0 and CIP1 (see Figure 1). The TX-CIPs are referred to as TX-CIP-0 and TX-CIP-1. The front electrostatic discharge point is located near the bottom of the TX-CIP.

The TX-CIP is hot-removable and hot-insertable.

Control Plane Ports

Each TX-CIP contains four RJ-45 ports labeled LCC0 through LCC3. These ports provide T640 router control by connecting to T-CBs in up to four T640 routers through UTP Category 5 Ethernet cables. TX-CIP-0 and TX-CIP-1 are used to connect to T-CB-0 and T-CB-1 in each T640 router.

Note: The RJ-45 ports labeled LCC4 through LCC7 on a TX-CIP are reserved for future use.

Routing Engine Ports

Each TX-CIP has three ports for connecting the corresponding host subsystem to external management devices (see Figure 1). From these management devices, you can use the CLI to configure the TX Matrix router. The ports on TX-CIP-0 connect to the Routing Engine in slot RE0, and the ports on TX-CIP-1 connect to the Routing Engine in slot RE1.

• One 10/100-Mbps ETHERNET port for connecting to a management network—Connects the Routing Engine through an Ethernet connection to a management LAN (or any other device that plugs into an Ethernet connection) for in-band management. The port uses an autosensing RJ-45 connector to support both 10- and 100-Mbps connections. Two small LEDs on the left edge of the port indicate the connection in use: the LED labeled ETHERNET lights yellow or green for a 10-Mbps or 100-Mbps connection, and the LED labeled ACT lights green when traffic is passing through the port.

  Note: If a TX Matrix router contains two host subsystems, connect both TX-CIPs to your external management network.

• CONSOLE—One asynchronous serial port for connecting the Routing Engine to a system console through an RS-232 (EIA-232) serial cable.
• AUXILIARY—One asynchronous serial port for connecting the Routing Engine to a laptop, modem, or other auxiliary device through an RS-232 (EIA-232) serial cable.

Alarm Relay Contacts

Each TX-CIP has two alarm relay contacts—labeled RED ALARM and YELLOW ALARM—for connecting the TX Matrix router to external alarm devices (see Figure 1). Whenever a system condition triggers either the red or yellow alarm on the craft interface, the alarm relay contacts are also activated. The alarm relay contacts are located below the Routing Engine ports.