PTSP Operational Mode Commands
Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the packet-triggered subscribers and policy control (PTSP) services. Commands are listed in alphabetical order.
Table 1: PTSP Operational Mode Commands
Task | Command |
|---|---|
Clear the packet-triggered subscriber session and log out the specified subscriber. | |
Display bandwidth information about the packet-triggered subscribers. | |
Display information about the active dynamic policies applied to the specific subscribers. | |
Display information about the data flows associated with the specific subscriber. | |
Display information about the active packet-triggered subscriber sessions on the router. | |
Display information about the data traffic statistics for the specified packet-triggered subscriber and for each service rule attached to that subscriber. |
 | Note: PTSP services are supported on the MultiServices Dense Port Concentrator (MS-DCP) on the MX Series routers. |
| Note: For information about how to configure the PTSP services, see the Junos Subscriber Access Configuration Guide. |
