PPPoE Interface Operational Mode Commands
Table 1 summarizes the command-line interface (CLI) commands that you can use to monitor and troubleshoot Point-to-Point Protocol over Ethernet (PPPoE) interfaces. Commands are listed in alphabetical order.
Table 1: PPPoE Interfaces Operational Mode Commands
Task | Command |
|---|---|
Clear PPPoE sessions. | |
Clear PPPoE session statistics. | |
Display interface-specific information about PPPoE-configured interfaces. | |
Display session-specific information about PPPoE-configured interfaces | |
Display PPPoE service name table information. | |
Display PPPoE active session information. | |
Display PPPoE session statistics. | |
Display PPPoE underlying interface information. | |
Display PPPoE version information. |
 | Note: PPPoE interfaces are supported on Fast Ethernet and ATM-over-ADSL and ATM-over-SHDSL interfaces on the J Series routers. PPPoE interfaces connect multiple PPPoE-client hosts on an Ethernet LAN to a remote site through a J Series Services Router. The J Series router can only be configured as a PPPoE client. Hosts share a common digital subscriber line (DSL), a cable modem, or a wireless connection to the Internet. For information about how to configure PPPoE interfaces, see the J Series Services Router Basic LAN and WAN Access Configuration Guide or the Junos Network Interfaces Configuration Guide. For information about monitoring and troubleshooting Fast Ethernet interfaces, see Ethernet Interface Operational Mode Commands. For information about monitoring and troubleshooting ATM-over-ADSL and ATM-over-SHDSL, interfaces, see ATM Interface Operational Mode Commands. |
