Intrusion Detection Service Operational Mode Commands
Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the intrusion detection service (IDS). Commands are listed in alphabetical order.
Table 1: IDS Operational Mode Commands
Task | Command |
|---|---|
Clear (set to zero) IDS events and event information. | |
Clear the IDS events for a particular address that might be under attack. | |
Clear the IDS attack source and destination address pair table. | |
Clear all IDS events for addresses that are suspected attackers. | |
Display IDS event information. |
 | Note: IDS is supported on the adaptive services interface on the following routers:
IDS is also supported on the redundant adaptive services interface (rspnumber) on M Series and T Series routers. |
| Note: For information about how to configure IDS, see the Junos Services Interfaces Configuration Guide. |
