PIM Mode-Independent Configuration Overview
This chapter discusses Protocol Independent Multicast (PIM) features that you can configure on an interface regardless of its PIM mode (sparse, dense, or sparse-dense mode).
If you configure PIM on an aggregated (ae- or as-) interface, each of the interfaces in the aggregate is included in the multicast output interface list and carries the single stream of replicated packets in a load-sharing fashion. The multicast aggregate interface is “expanded” into its constituent interfaces in the next-hop database. For information about aggregate interfaces, see the Junos Network Interfaces Configuration Guide.
Related Topics
- Configuring PIM Dense Mode Properties
- Configuring PIM Sparse-Dense Mode Properties
- Minimum PIM Sparse Mode Configuration
- Enabling PIM Sparse Mode
- Configuring PIM Sparse Mode Graceful Restart
- Configuring Local PIM RPs
- Configuring Static PIM RPs
- Configuring PIM Bootstrap Properties
- Configuring PIM Auto-RP
- Configuring Register Message Filtering on a PIM RP or DR
- Configuring PIM Join Load Balancing
- Modifying the Join State Timeout
- Configuring PIM Embedded RP for IPv6
- Configuring the PIM Assert Timeout
- Configuring the PIM SPT Threshold Policy
- Configuring Any-Source Multicast for Draft-Rosen VPNs
