Adaptive Services Interface Operational Mode Commands

Table 126 summarizes the command line interface (CLI) commands that you can use to monitor and troubleshoot adaptive services operations.

Table 126: Adaptive Services Interface Operational Mode Commands

Task	Command
(M Series and T Series routers only) Manually revert to the primary adaptive services interface or link services IQ interface, or to switch from the primary to the secondary interface.	request interface (revert \| switchover) (Adaptive Services)
Display status information about the specified adaptive services interface.	show interfaces (Adaptive Services)
(M Series and T Series routers only) Display status information about the specified redundant adaptive services configuration.	show interfaces (Redundant Adaptive Services)
(M series , T Series , and MX Series routers only) Display general information about adaptive services and link services intelligent queuing (IQ) interfaces redundancy.	show interfaces redundancy

Note: For information about how to configure adaptive services, see the JUNOS Services Interfaces Configuration Guide.