SIP Routing Overview
The BSG uses SIP routing to determine the next-hop and exit point of SIP messages. You define SIP routing in policies. Each incoming SIP request is matched to a policy that specifies how the SIP request is routed.
You can configure the policy to match incoming SIP requests to:
- Contact field in the SIP message
- Request URI field in the SIP message
- Type of SIP method
- Source addresses and masks
You can specify the following actions to be taken on SIP requests that match the policy:
- Next hop—You can specify the next-hop as a request URI or as a static IP address.
- Egress service point—You can specify the IP address of the interface from which SIP requests exit the router and set a port number and transport protocol used to route the request.
