Supported Frame Relay Interface Standards

The JUNOS Software substantially supports the following standards for Frame Relay interfaces.

• American National Standards Institute (ANSI), Annex D, Additional Procedures for Permanent Virtual Connections (PVCs) Using Unnumbered Information Frames to T1.617-1991, Integrated Services Digital Network (ISDN)—Signaling Specification for Frame Relay Bearer Service for Digital Subscriber Signaling System Number 1 (DSS1)
• Broadband Forum standard FRF.12, Frame Relay Fragmentation Implementation Agreement
• FRF.15, End-to-End Multilink Frame Relay Implementation Agreement
• FRF.16.1, Multilink Frame Relay UNI/NNI Implementation Agreement
• International Telecommunication Union–Telecommunication Standardization (ITU–T), Annex A, Additional procedures for Permanent Virtual Connection (PVC) status management (using Unnumbered Information frames) to Recommendation Q.933, ISDN Digital Subscriber Signalling System No. 1 (DSS1) - Signalling specifications for frame mode switched and permanent virtual connection control and status monitoring
• RFC 1973, PPP in Frame Relay
• RFC 2427, Multiprotocol Interconnect over Frame Relay (obsoletes RFC 1490)
• RFC 2590, Transmission of IPv6 Packets over Frame Relay Networks Specification
• Internet draft draft-martini-frame-encap-mpls-01.txt, Frame Relay Encapsulation over Pseudo-Wires (expires December 2002)

  Translation of the command/response bit and sequence numbers and padding are not supported.

Related Topics

• Accessing Standards Documents on the Internet