Resolved Issues

This section describes issues resolved in Junos Space Release 1.1:

• Modify VPLS Service is not supported if you use a customized service definition.
• MAC security settings are not pushed to the device during deployment.
• Automatic selection of VLAN IDs does not work correctly in service orders that are based on a customized service definition in which Auto pick is selected in the VLAN ID selection field and the Editable in service order check box is unchecked. These selections in the service definition should create a service order in which the VLAN ID is automatically selected and the Auto pick VLAN ID column in the Endpoint Settings table cannot be edited. Instead, the Endpoint Settings table in the service order shows the Autopick VLAN ID checkbox unchecked and it cannot be edited. As a result, automatic selection of the VLAN ID does not take place.
• Adding an endpoint to a VPLS service does not work for a service that specifies a VLAN range. After you add the endpoint in the Modify Service screens, the start and end values for the VLAN range change to 0 and 0. The Junos Space software issues an error when you attempt to save the service order. [PR/481555]
• Automatic rollback of failed service order deployments is not supported.
• The Modify Service action allows you to change the physical interface MTU value on a service provisioned interface. Changing the physical interface MTU will affect other services provisioned on that interface.
• After starting discovery, the status graph might remain blank for about 4 or 5 seconds.
• The Junos Space Appliance Settings menu might erroneously display the Expand VM drive size option for a physical appliance. This option should appear only for the virtual appliance.
• The MAC learning security setting is always set to false. This value works for almost all VPLS use cases. The MAC statistics security setting is also always set to false.
• Creating a customized service definition does not perform validation on the traffic type.
• The Modify Loopback Address action does not show other loopback addresses configured on the same logical interface in the device. It shows a loopback address configured on a different logical interface, but does not change the device loopback address in Junos Space.
• Contextual launching does not work from the Role Discovery Status chart.
• If vlan-ccc physical encapsulation was configured on a UNI before prestaging, Junos Space will not allow you to use VLAN IDs less than 512 even when deploying a point-to-point or VPLS service order with flexible-ethernet-services physical encapsulation on that UNI.
• The “Percent Complete” column in the table view of the Manage Jobs inventory page might not display the “Percentage of job execution completed” for intermediate states.