M320 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port
The port on the CIP labeled ETHERNET is an autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a management LAN (or other device that supports out-of-band management). Table 1 describes the RJ-45 connector pinouts.
Table 1: RJ-45 Connector Pinouts
Pin |
Signal |
|---|---|
1 |
TX+ |
2 |
TX – |
3 |
RX+ |
4 |
Termination network |
5 |
Termination network |
6 |
RX– |
7 |
Termination network |
8 |
Termination network |
