• Downloads
• Configuring PPPoE-Based Radio-to-Router Protocols    

• Related Topics
• For information on configuring a PPPoE server, see “Configuring Point-to-Point Protocol over Ethernet” in the JUNOS Network Interfaces Configuration Guide.

Configuring PPPoE-Based Radio-to-Router Protocols

To configure PPPoE on an LN1000 router, perform the following tasks:

1. Configure PPPoE encapsulation for an Ethernet interface.
2. Configure resource-component-variables on the logical Ethernet interface.
3. Specify the logical Ethernet interface as the underlying interface for the PPPoE session.
4. Configure the operational mode as server.
5. Optionally, identify the access concentrator by a unique name.
6. Optionally, specify how many seconds to wait before attempting to reconnect.
7. Optionally, provide a name for the type of service provided by the access concentrator.
8. Optionally, configure the maximum transmission unit (MTU) of the interface.
9. Optionally, configure the MTU size for the protocol family.
10. Optionally, disable the sending of keepalive messages on the logical interface.