Configuring Traffic Filtering Based on the IP Header

To filter traffic based on the IP header, include the vrf-table-label statement:

You can include the vrf-table-label statement at the following hierarchy levels:

• [edit routing-instances routing-instance-name]
• [edit logical-systems logical-system-name routing-instances routing-instance-name]

You can configure the vrf-table-label statement for both IPv4 and IPv6 Layer 3 VPNs. If you configure the vrf-table-label statement for a dual-stack VRF routing table (where both IPv4 and IPv6 routes are supported), the vrf-table-label statement applies to both the IPv4 and IPv6 routes and the same label is advertised for both sets of routes.

For more information about traffic filtering based on the IP header, see the following sections:

• Egress Filtering Options
• Support for Ethernet, SONET/SDH, and T1/T3/E3 Interfaces
• Support for Aggregated and VLAN Interfaces
• Support for ATM and Frame Relay Interfaces
• Support for Multilink PPP and Multilink Frame Relay Interfaces
• Support for Packets with Null Top Labels
• Other Limitations

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.