Chassis Interface Naming

You configure some PIC properties, such as framing, at the [edit chassis] hierarchy level. Chassis interface naming varies depending on the routing hardware. For standalone routing platforms, you must specify the FPC and PIC numbers.

For routing matrixes, you must specify the LCC, FPC, and PIC numbers, as follows:

• Standalone routing platform interface naming:

  [edit chassis]

  fpc slot-number {

  pic pic-number {

  ...

  }

  }

• Routing matrix interface naming:

  [edit chassis]

  lcc lcc-number {

  fpc slot-number { # Use the hardware FPC slot number

  pic pic-number {

  ...

  }

  }

For the FPC slot number, specify the actual hardware slot number, as labeled on the T640 routing node chassis. Do not use the corresponding software FPC number shown in Table 9.

For more information about the [edit chassis] hierarchy, see the JUNOS System Basics Configuration Guide.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.