 | Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |
- show system statistics icmp6
- show system statistics icmp6
- <all-lcc | lcc number | scc>
Command introduced before JUNOS Release 7.4.
Display system-wide Internet Control Message Protocol for IPv6 (ICMP6) statistics.
all-lcc — (Routing matrix only) (Optional) Display system statistics for ICMPv6 for all T640 routing nodes (or line-card chassis) connected to a TX Matrix platform.
lcc number — (Routing matrix only) (Optional) Display system statistics for ICMPv6 for a specified T640 routing node (or line-card chassis) connected to a TX Matrix platform. Replace number with a value from 0 through 3.
scc — (Routing matrix only) (Optional) Display system statistics for ICMPv6 for the TX Matrix platform (or switch-card chassis).
By default, when you issue the show system statistics icmpv6 command on a TX Matrix master Routing Engine, the command is broadcast to all the T640 master Routing Engines connected to it. Likewise, if you issue the same command on the TX Matrix backup Routing Engine, the command is broadcast to all the T640 backup Routing Engines that are connected to it.
view
Output field descriptions to be provided.
user@host> show system statistics icmp6
icmp6:
0 calls to icmp_error
0 errors not generated because old message was icmp error or so
0 errors not generated because rate limitation
0 messages with bad code fields
0 messages < minimum length
0 bad checksums
0 messages with bad length
Histogram of error messages to be generated:
0 no route
0 administratively prohibited
0 beyond scope
0 address unreachable
0 port unreachable
0 packet too big
0 time exceed transit
0 time exceed reassembly
0 erroneous header field
0 unrecognized next header
0 unrecognized option
0 redirect
0 unknown
0 message responses generated
0 messages with too many ND options
| Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |