Packet Gateway Control Protocol Operational Mode Commands

[Contents] [Prev] [Next] [Index] [Report an Error]

Table 241 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Packet Gateway Control Protocol (PGCP) services. Commands are listed in alphabetical order.

Table 241: PGCP Services Operational Mode Commands

Task	Command
Clear information about PGCP gates.	clear services pgcp
Display information about the PGCP configuration.	show services pgcp active-configuration
Display summary information about PGCP gates.	show services pgcp gates
Display information about H.248 terminations.	show services pgcp root-termination
Display information about the packet gateway statistics.	show services pgcp statistics
Display information about PGCP conversations.	show services pgcp conversations
Display information about PGCP flows.	show services pgcp flows
Display summary information about PGCP terminations.	show services pgcp terminations

Note: PGCP services are supported on the MultiServices (sp-fpc/pic/port) interface on T640 routing nodes.

Note: For information about how to configure PGCP services, see the JUNOS Multiplay Solutions Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]