Intrusion Detection Service Operational Mode Commands

[Contents] [Prev] [Next] [Index] [Report an Error]

Table 209 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the intrusion detection service (IDS). Commands are listed in alphabetical order.

Table 209: IDS Operational Mode Commands

Task	Command
Clear (set to zero) IDS events and event information.	clear services ids
Clear the IDS events for a particular address that might be under attack.	clear services ids destination-table
Clear the IDS attack source and destination address pair table.	clear services ids pair-table
Clear all IDS events for addresses that are suspected attackers.	clear services ids source-table
Display IDS event information.	show services ids

Note: IDS is supported on the adaptive services interface on the following routing platforms:

J-series routing platform—sp-pim/0/slot
M-series and T-series routing platforms—sp-fpc/pic/port

IDS is also supported on the redundant adaptive services interface (rspnumber) on M-series and T-series routing platforms.

Note: For information about how to configure IDS, see the JUNOS Services Interfaces Configuration Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]