[Contents] [Prev] [Next] [Index] [Report an Error]

Verifying H.248 Parameters Set by the PGC

Purpose

Verify the H.248 parameters that are set by the PGC.

Action

user@sp-pg-router> show services pgcp
terminations vpg—1 h248

Termination information:
ip/4/vif-0/2 {
      MEDIA {
        TERMINATIONSTATE { SERVICESTATES = INSERVICE },
        STREAM = 1 {
          LOCALCONTROL { MODE = SENDRECEIVE,
                         DS/DSCP = 00,
                         TMAN/MBS = 0,
                         TMAN/PDR = 0,
                         TMAN/POL = OFF,
                         TMAN/SDR = 0,
                         MGCINFO/DB = 00,
                         GM/RSB = ON,
                         GM/SAF = OFF,
                         GM/SPF = OFF,
                         GM/SPR = 0,
                         GM/ESAS = OFF,
                         GM/ESPS = OFF,
                         GM/LSP = 0 },
          LOCAL {
v=0
c=IN IP4 10.10.0.5
m=- 1024 RTP/AVP -
b=AS:0
          },
          REMOTE {
v=0
c=IN IP4 10.0.0.1
m=- 20002 RTP/AVP -
b=AS:0
          }
        }
      },
      EVENTS = 1001 { NT/QUALERT { TH = 99, STREAM = 1 } },
      SIGNALS
    }

ip/4/vif-0/3 {
      MEDIA {
        TERMINATIONSTATE { SERVICESTATES = INSERVICE },
        STREAM = 1 {
          LOCALCONTROL { MODE = SENDRECEIVE,
                         DS/DSCP = 00,
                         TMAN/MBS = 1500,
                         TMAN/PDR = 0,
                         TMAN/POL = OFF,
                         TMAN/SDR = 125000,
                         MGCINFO/DB = 00,
                         GM/RSB = ON,
                         GM/SAF = ON,
                         GM/SAM = "[20.0.0.1]",
                         GM/SPF = OFF,
                         GM/SPR = 0,
                         GM/ESAS = OFF,
                         GM/ESPS = OFF,
                         GM/LSP = 0 },
          LOCAL {
v=0
c=IN IP4 11.0.0.5
m=- 1024 RTP/AVP -
b=AS:0
          },
          REMOTE {
v=0
c=IN IP4 4.0.0.1
m=- 10002 RTP/AVP -
b=AS:0
          }
        }
      },
      SIGNALS
    }
{master}

Meaning

The show services pgcp terminations vpg-name h248 command presents the H.248 parameters as they have been set through PGCP requests and commands from the PGC. Comparing this output with the expected PGCP requests reveals whether there was a problem with the requests and commands that the PGC sent to the VPG.

[Contents] [Prev] [Next] [Index] [Report an Error]