[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring the Method and Reason in ServiceChange Commands for Virtual Interfaces

Step-by-Step Procedure

To configure the method and reason in ServiceChange commands for virtual interfaces:

  1. Access the configuration of the service change virtual interface indications properties.
    [edit services pgcp]
    user@host#edit gateway vpg-1 h248-options service-change virtual-interface-indications
  2. Specify the method and reason that the VPG includes in Service-Interruption ServiceChange commands that it sends to the PGC when a virtual interface changes to Out-of-Service because of an administrative operation.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-down administrative forced-906
  3. Specify the method and reason that the VPG includes in Service-Interruption ServiceChange commands that it sends to the PGC when a virtual interface transitions to Out-of-Service because of a failure.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-down failure forced-906
  4. Specify the method and reason that the VPG includes in Notification ServiceChange commands that it sends to the PGC when a virtual interface transitions between the Forwarding and Draining states.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-down graceful none
  5. Specify the method and reason that the VPG includes in Service-Interruption ServiceChange commands that it sends to the PGC when the virtual interface transitions to Out-of-Service because of a link loss.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-down link-loss forced-906
  6. Specify the method and reason that the VPG includes in Notification ServiceChange commands that it sends to the PGC when the virtual interface transitions from the Draining state to the Forwarding state.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-up cancel-graceful restart-918
  7. Specify the method and reason that the VPG includes in Service-Restoration ServiceChange commands that it sends to the PGC when a virtual interface transitions to In-Service.
    [edit services pgcp gateway vpg-1 h248-options service-change virtual-interface-indications]
    user@host#set virtual-interface-up warm restart-900
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.