[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring the Method and Reason in ServiceChange Commands for Control Associations

Step-by-Step Procedure

To configure the method and reason in ServiceChange commands for control associations:

  1. Access the configuration of the service change control association indications properties.
    [edit services pgcp]
    user@host#edit gateway vpg-1 h248-options service-change control-association-indications
  2. Specify the method and reason that the VPG includes in Registration Request ServiceChange commands when it attempts to reregister with the PGC or register with a new PGC after the control association is disconnected.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set disconnect controller-failure restart-902
  3. Specify the method and reason that the VPG includes in Registration Request ServiceChange commands when it attempts to reregister with the PGC or register with a new PGC after the control association is disconnected.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set disconnect reconnect restart-902
  4. Specify the method and reason that the VPG includes in Unregistration Messages in ServiceChange commands that it sends to the PGC when a control association transitions to Out-of-Service because of an administrative operation.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set down administrative forced-908
  5. Specify the method and reason that the VPG includes in Unregistration Messages in ServiceChange commands that it sends to the PGC when a control association transitions to Out-of-Service because of a failure.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set down failure forced-904
  6. Specify the method and reason that the VPG includes in Notification ServiceChange commands that it sends to the PGC when the control association transitions from In-Service to Out-of-Service-Graceful.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set down graceful graceful-905
  7. Specify the method and reason that the VPG includes in Notification ServiceChange commands that it sends to the PGC when the control association has returned to the Connected state.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set up cancel-graceful restart-918
  8. Specify the method and reason that the VPG includes in Registration ServiceChange commands when it attempts to register with a new PGC following a cold failover.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set up failover-cold failover-920
  9. Specify the method and reason that the VPG includes in Registration ServiceChange commands when it attempts to register with a new PGC following a warm failover.
    [edit services pgcp gateway vpg-1 h248-options service-change control-association-indications]
    user@host#set up failover-warm restart-902
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.