| Identification |
|
Host Name (required)
|
Defines the hostname of the routing platform.
|
Type the hostname.
|
|
Domain Name
|
Defines the network or subnetwork that the machine belongs to.
|
Type the domain name.
|
|
Root Password (required)
|
Sets the root password that user “root” can use
to log in to the routing platform.
|
Type a plain-text password that the system encrypts.
Note:
After a root password has been defined, it is required when
you log in to the J-Web user interface or the CLI.
|
|
Verify Root Password (required)
|
Verifies the root password has been typed correctly.
|
Retype the password.
|
| Time |
|
Time Zone
|
Identifies the time zone that the routing platform is located in.
|
From the list, select the appropriate time zone.
|
|
NTP Servers
|
Specify an NTP server that the routing platform can reach to synchronize
the system time.
|
To add an IP address, type it in the box to the left of the
Add button, then click Add.
To delete an IP address, click it in the box above the Add button,
then click Delete.
|
|
Current System Time
|
Synchronizes the system time with the NTP server, or manually
sets the system time and date.
|
|
| Network |
|
DNS Name Servers
|
Specify a DNS server that the routing platform can use to resolve
hostnames into addresses.
|
To add an IP address, type it in the box to the left of the
Add button, then click Add.
To delete an IP address, click it in the box above the Add button,
then click Delete.
|
|
Domain Search
|
Adds each domain name that the routing platform is included in
to the configuration so that they are included in a DNS search.
|
To add a domain name, type it in the box to the left of the
Add button, then click Add.
To delete a domain name, click it in the box above the Add button,
then click Delete.
|
|
Default Gateway
|
Defines a default gateway through which to direct packets addressed
to networks not explicitly listed in the routing table.
|
Type a 32-bit IP address, in dotted decimal notation.
|
|
Loopback Address
|
Defines a reserved IP address that is always available on the routing platform.
If no address is entered, this address is set to 127.0.0.1/32.
|
Type a 32-bit IP address and prefix length, in dotted decimal
notation.
|
|
fe-0/0/0 Address (on J2300, J4300 and J6300 routing
platforms)
ge-0/0/0 Address (on J4350 and J6350 routing platforms)
fxp0 Address (on M-series routing platforms)
|
Defines the IP address and prefix length of the management interface.
The management interface is used for accessing the routing platform.
The DHCP client sets this address to 192.168.1.1/24 if no
DHCP server is found.
|
Type a 32-bit IP address and prefix length, in dotted decimal
notation.
Note:
You must enter the address for the management interface on the
Quick Configuration Set Up page before you click Apply. If you do not manually configure this address, you will lose your
connection to the J-Web interface when you click Apply.
|
| Management
Access |
|
Allow Telnet Access
|
Allows remote access to the routing platform using Telnet.
|
To enable Telnet access, select the check box.
|
|
Allow JUNOScript over Clear-Text Access
|
Allows JUNOScript to access the routing platform using a protocol
for sending unencrypted text over a TCP connection.
|
To enable JUNOScript access over clear text, select the check
box.
|
|
Allow SSH Access
|
Allows remote access to the routing platform using SSH.
|
To enable SSH access, select the check box.
|
