Pseudowires — Provision L2circuit Pseudowires — Add/Edit/Delete Pseudowires Dialog Box

Use the Add/Edit/Delete Pseudowires dialog box to create, modify, or delete pseudowires.

Click Provisioning > Pseudowires> Provision L2circuit Pseudowires, and then click Next in the Select Device dialog box after entering the details.

Superuser, read-write

Source Device Name drop-down list box—Select a source device from the drop-down list box.

Destination Device Name drop-down list box—Select a destination device from the drop-down list box.

Interface Type drop-down list box—Select an interface type from the drop-down list box.

Select Template drop-down list box—Select a template you have earlier defined from the drop-down list box.

Select Tunnel drop-down list box—Select a tunnel you have earlier created from the drop-down list box.

Virtual Circuit ID—Enter the virtual circuit ID for the pseudowire.

Description—Enter a description of the pseudowire.

VPI—Common for both source and destination endpoints. Applicable only to ATM pseudowires.

VCI—Common for both source and destination endpoints. Applicable only to ATM pseudowires.

VLAN ID—Common for both source and destination endpoints. Applicable only to Ethernet pseudowires.

Provide Source Endpoint Details: allows you to enter details of the source endpoint as follows:

CE Interface—Select the CE facing interface from the drop-down list box.
Logical Unit—Enter the logical unit for the CE interface.
LSP Name—Select an LSP from the drop-down list box.
Select GRE Interface—Select a GRE interface from the drop-down list box if you have selected a GRE tunnel in the Select Tunnel drop-down list box.
Logical Unit—Enter the logical unit for the GRE interface.

Provide Destination Endpoint Details: allows you to enter details of the destination endpoint as follows:

CE Interface—Select the CE facing interface from the drop-down list box.
Logical Unit—Enter the logical unit for the CE interface.
LSP Name—Select an LSP from the drop-down list box.
Select GRE Interface—Select a GRE interface from the drop-down list box if you have selected a GRE tunnel in the Select Tunnel drop-down list box.
Logical Unit—Enter the logical unit for the GRE interface.

Add Entry button—Click this to add the pseudowire or save the modifications you made.

Edit button—Click this to make modifications to the pseudowire details.

Delete button—Click this to delete the tunnel.

Force Deploy button—Click this to push the configuration details to the devices even if you have not modified them.

Previous button—Click this to go to step 1: Select Device dialog box.

Next button—Click this to go to step 3: Confirm Add/Edit/Delete Pseudowires dialog box.

The table at the bottom of the wizard displays:

State: State can be one of the following:
- New: If the pseudowire is new.
- Modified: If a exiting pseudowire is modified.
- Unchanged: If a existing pseudowire is unchanged.
Source Device Name
Source CE Interface
Destination Device Name
Destination CE Interface
Virtual Circuit ID