Filtering and Testing Pseudowires

You can use filtering criteria to monitor pseudowires that are already provisioned. Users with read-only, read-write and superuser privileges have access to the filtering wizard.

To filter and test pseudowires

1. Click Filter and Test l2circuit Pseudowires.
2. Select one of the option buttons under Select Filter Options. The following filtering criteria are supported:

   

   • All Pseudowires: Select this option button to view all the pseudowires provisioned by JUNOScope.
   • Select Device Group(s): Select this option button and select one or multiple device groups to view all the pseudowires that are provisioned on devices in the selected groups.
   • Select Devices: Select this option button and select devices from the list box to view pseudowires provisioned on those devices.
   • Select Pseudowire Endpoints: Select this option button and select, from the drop-downs the device names for endpoints to view pseudowires provisioned between these endpoints.
   • Select Virtual Circuit ID: Select this option and specify a virtual circuit id to view all the pseudowires having the Virtual Circuit ID.
3. Click OK. The pseudowires are filtered according to the criteria you specified and displayed in a list.

   

4. Click View after selecting a pseudowire to display the details of the pseudowire.
5. Click Test to send show l2circuit connections command to each end point of the pseudowire, and to show the results.

   

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.