Downloading the JUNOScope Software from the Juniper Networks Software Web Page

To download the JUNOScope software, follow these steps:

1. Using a Web browser, go to the following location:

   http://www.juniper.net/support/csc/swdist-encr/swdist-jtk/

2. Log in to the Juniper Networks authentication system using your username and password supplied by a Juniper Networks representative. To download the software, you must have a service contract and an access account. If you do not have an access account, complete the registration form at the Juniper Networks Web site, https://www.juniper.net/registration/Register.jsp.
3. Download the JUNOScope software to your local UNIX host.
4. Start the JUNOScope installation program with the following command:

   hostname% download-directory/jtk-install-X.XXX.X-sunos5-sparc.sh install-directory

   or

   hostname% download-directory/jtk-install-X.XXX.X-linux2-i386.sh install-directory

   Replace download-directory with the directory into which you downloaded the JUNOScope software from the software download page.

   /jtk-install-X.XXX.X-sunos5-sparc.sh or jtk-install-X.XXX.X-linux2-i386.sh is the JUNOScope software file. Replace X with the software version to download (for example, 7.3R1.3).

   Replace install-directory with the directory in which to install the JUNOScope software. If you do not specify an installation directory, the software is installed in the current directory.

   For information about installing JUNOScope, see Installing the JUNOScope Software.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.