Configuring Protocols

You can specify the protocols to be configured on each interface.

To configure a protocol, follow these steps:

1. Click Configure Protocols under MPLS/GRE Tunnels. The Configure Protocols dialog box appears.

   

2. From the Device Name drop-down, select the name of the device on which you want to configure the protocols.
3. From the Protocols drop-down, select one of the following: ISIS, MPLS, LDP, RSVP, OSPF, INET.
4. Click Open. Depending on the protocol selected, parameters specific to the protocol appear. The parameters for specific interfaces are described in the following sections.

   Note: For all protocols except INET, you can select the Enable on all Interfaces check box. For protocol-specific parameters, see the following sections.

5. Click Save to save the interfaces to be used during MPLS/GRE Tunnel Provisioning.

   Note: When you click Save, the protocol information is saved to the JUNOScope database. Actual configuration will be pushed to device only during provisioning of MPLS/GRE tunnels.

For IS-IS

1. Select the interface(s).
2. Specify the Logical Unit.
3. Click Disable if you want to disable IS-IS on the selected interface.
4. Select the Level from the drop-down.
5. Click Add.
6. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

For LDP

1. Select the interface from the list of interfaces.
2. Specify the Logical Unit.
3. Check Disable check box if you want to disable LDP on the selected interface.
4. Click Add.
5. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

For MPLS

1. Select the interface(s).
2. Specify the Logical Unit.
3. Check Disable check box to disable MPLS on the selected interface.
4. Click Add.
5. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

For OSPF

1. Select the interface(s).
2. Specify the Logical Unit. You can select the Disable check box.
3. Specify the Area.
4. Select the Traffic Engineering (TE) check box to enable MPLS TE on the interface.
5. Click Add.
6. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

For RSVP

1. Select the interface from the list of interfaces.
2. Specify the Logical Unit. You can select the Disable check box.
3. Check Disable check box if you want to disable RSVP on the selected interface.
4. Click Add.
5. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

For INET

1. Select the interface(s).
2. Specify the Logical Unit.
3. Check the Disable check box if you want to disable INET on the selected interface.
4. Specify the IP Address and Numeric Subnet Mask (0–32).
5. Click Add.
6. To remove an interface from the configuration, select an interface and click Remove. You can click Remove All to remove all the interfaces on which the protocol is configured.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.