Adding an Access Method

You are not done setting up access methods without at least one authentication information entry. You can use the Add button to add a new entry, or edit or delete an existing entry.

To add an access method, follow these steps:

1. From the JUNOScope main window, click Settings > Access Methods. The Access Methods dialog box appears.
2. Click Add. The Add Access Method dialog box appears.
3. In the Access Method Name text box, type a name for the remote router access method to use in the JUNOScope software. This is the access method name used in the Add Device dialog box. See Adding a Device.
4. In the Access Method Type drop-down list box, select a supported access protocol that is configured on the router:,JUNOScript over clear-text, JUNOScript over SSL, or NETCONF over SSH.

   Note: The NETCONF over SSH option is available only if you have installed IP Backhaul Manager license.

   Note: You must choose the NETCONF over SSH option if you want to access BXOS devices. BXOS devices support only the NETCONF over SSH access method.

5. In the Authentication Information drop-down list box, select an authentication name. This is the same name that you created in the Add Authentication Information dialog box.
6. Click OK. The new access method is listed in the Access Methods dialog box.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.