<if-config-flags>

Usage

<physical-interface | logical-interface>
    <if-config-flags>
        <iff-none/>
        <iff-hardware-down/>
        <iff-down/>
        <iff-up/>
        <iff-admin-down/>
        <iff-admin-up/>
        <iff-link-down/>
        <iff-device-down/>
        <iff-point-to-point/>
        <iff-point-to-multipoint/>
        <plp-to-clp/>
        <iff-multiaccess/>
        <iff-change/>
        <iff-inverse-arp/>
        <iff-no-multicast/>
        <iff-multicast/>
        <iff-promiscuous/>
        <iff-all-multicast/>
        <iff-snmp-traps/>
        <iff-rx-passive/>
        <iff-tx-passive/>
        <iff-ccc-down/>
        <iff-clear-df/>
        <iff-tunnel-reassembly/>
        <iff-acfc/>
        <iff-pfc/>
        <iff-rdd/>
        <iff-looped/>
        <internal-flags>internal-flags</internal-flags>
    </if-config-flags>
</physical-interface | logical-interface>

Description

No documentation is available yet.

Contents

<iff-acfc>—PPP Address/Control field compression is enabled.

<iff-admin-down>—Interface is in test mode, which means that some sanity checking, such as loop detection, is disabled.

<iff-admin-up>—No documentation is available yet.

<iff-all-multicast>—No multicast filtering (multicast promiscuous).

<iff-ccc-down>—CCC/TCC endpoint is down.

<iff-change>—No documentation is available yet.

<iff-clear-df>—Clear Don't-Fragment bit.

<iff-device-down>—No documentation is available yet.

<iff-down>—No documentation is available yet.

<iff-hardware-down>—Interface is nonfunctional or incorrectly connected.

<iff-inverse-arp>—No documentation is available yet.

<iff-link-down>—Interface keepalives have indicated that the link is incomplete.

<iff-looped>—Logical interface is looped.

<iff-multiaccess>—No documentation is available yet.

<iff-multicast>—No documentation is available yet.

<iff-no-multicast>—Interface does not support multicast traffic.

<iff-none>—No documentation is available yet.

<iff-pfc>—PPP Protocol field compression is enabled.

<iff-point-to-multipoint>—No documentation is available yet.

<iff-point-to-point>—Interface is point-to-point.

<iff-promiscuous>—Interface is in promiscuous mode and will see frames addressed to all physical addresses.

<iff-rdd>—Redundancy device.

<iff-rx-passive>—Receive is disabled.

<iff-snmp-traps>—SNMP traps are enabled.

<iff-tunnel-reassembly>—Perform reassembly.

<iff-tx-passive>—Transmit is disabled.

<iff-up>—Interface is enabled and operational.

<internal-flags>—Hexadecimal value of internal flag bits.

<plp-to-clp>—No documentation is available yet.