J-Web Configuration

Note: First, do basic chassis cluster and management interfaces setup.

1. Fabric interface

   See step 1 in CLI Configuration.

2. Redundancy groups
   • Select Configuration > Quick Configuration > Chassis Cluster.
   • Enter the following, then click Apply:
     • Redundant ether-Interface Count: 1
     • Heartbeat Interval: 1000
     • Heartbeat Threshold: 3
     • Nodes: 0
     • Group Number: 1
     • Priorities: 100
   • Enter the following, then click Apply:
     • Nodes: 1
     • Group Number: 1
     • Priorities: 1
     • Interface Monitor—Interface: fe-1/0/0
     • Interface Monitor—Weight: 255
     • Interface Monitor—Interface: fe-5/0/0
     • Interface Monitor—Weight: 255
3. Redundant Ethernet interfaces
   • Select Configuration > Quick Configuration > Interfaces.
   • Select fe-1/0/0.
   • Enter the following:
     • Redundant Parent: reth0
   • Click Apply.
   • Select fe-5/0/0.
   • Enter the following:
     • Redundant Parent: reth0
   • Click Apply.
   • For other configuration settings in step 3, see step 3 in CLI Configuration.
4. Static routes (one to each ISP, with preferred route through ge-0/0/0)
   • Select Configuration > Quick Configuration > Routing and Protocols > Static Routing.
   • Click Add.
   • Enter the following, then click Apply:
     • Static Route Address: 0.0.0.0/0
     • Next-Hop Addresses: 1.4.0.1, 1.2.1.1
5. Security zone
   • See step 5 in CLI Configuration.
6. Access
   • See step 6 in CLI Configuration.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.