J-Web Configuration

To configure the ABC zone to allow use of all the supported application services as inbound services using the J-Web configuration editor:

1. Select Configuration>View and Edit>Edit Configuration.

   The Configuration page appears.

2. Next to Security, click Configure or Edit.
3. Next to Zones, click Configure or Edit.
4. Next to Security zone, click Add new entry.
5. In the Name box, type ABC and click OK.
6. Next to Host inbound traffic, click Configure or Edit.
7. To allow the security zone to use all of the supported application services, next to System services, click Add new entry.
8. From the Service name list, select All and click OK.

To enable FTP and telnet for interfaces such as ge-0/0/1.3 and ge-0/0/1:

1. Next to Interfaces, click Add new entry.
2. In the Interface unit box, type ge-0/0/1.3 and click OK.
3. Next to Host inbound traffic, click Configure or Edit.
4. Next to System services, click Add new entry.
5. From the Service name list, select ftp and click OK.
6. Next to Interfaces, click Add new entry.
7. In the Interface unit box, type ge-0/0/1.1 and click OK.
8. Next to Host inbound traffic, click Configure or Edit.
9. Next to System services, click Add new entry.
10. From the Service name list, select telnet and click OK.

To enable FTP and telnet for interface ge-0/0/1.3 and only SNMP for interface ge-0.0/1.1:

1. Next to Interfaces, click Add new entry.
2. In the Interface unit box, type ge-0/0/1.3 and click OK.
3. Next to Host inbound traffic, click Configure or Edit.
4. Next to System services, click Add new entry.
5. From the Service name list, select ftp and telnet, and click OK.
6. To enable SNMP for interface ge-0.0/1.1:
7. Next to Interfaces, click Add new entry.
8. In the Interface unit box, type ge-0/0/1.1 and click OK.
9. Next to Host inbound traffic, click Configure or Edit.
10. Next to System services, click Add new entry.
11. From the Service name list, select snmp and click OK.

To allow all configurable system services on the interface ge-0/0/1.3, except Telnet:

1. Next to Interfaces, click Add new entry.
2. In the Interface unit box, type ge-0/0/1.3 and click OK.
3. Next to Host inbound traffic, click Configure or Edit.
4. Next to System services, click Add new entry.
5. From the Service name list, select all and click OK.
6. Next to System services, click Add new entry.
7. From the Service name list, select telnet and click OK.
8. Select the Except check box and click OK.
9. If you are finished configuring the device, commit the configuration.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.