 |
Note: If you try to access the nodes in a cluster over the network before you configure the fxp0 interface, you will lose access to the cluster. |
You must assign a unique IP address to each node in the cluster to provide network management access. This configuration is not replicated across the two nodes.
|
Before You Begin |
|---|
|
Read: |
In an SRX-series chassis cluster, the fxp0 interface is a dedicated port.
In a J-series chassis cluster, you configure management access to the cluster by defining a unique hostname for each node and assigning a unique IP address to the fxp0 interface on each node. The fxp0 interface is created when the system reboots the devices after you designate one node as the primary and the other as the secondary.
|
Note: If you try to access the nodes in a cluster over the network before you configure the fxp0 interface, you will lose access to the cluster. |
This topic includes:
 | Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |